How to remove the
(see fig. 11)
The batteries in this shaver are not intended to be replaced by consum- ers. However, the batteries may be replaced at an authorized service center. The procedure described be- low is intended only for removal of the rechargeable batteries for the purpose of proper disposal.
1.Remove the screw (a) and the bottom cover (b).
2.Slide the trimmer handle up until it clicks in.
3.Remove the screw (c) and the panel cover (d).
4.Remove the six screws (e).
5.Remove the back panel (f).
6.Lift the battery block (g) and re- move it from the battery terminal sealing (h).
7.Remove the batteries from the battery block (g).
WARNING:
Do not attempt to replace the bat- teries for the purpose of reusing the shaver. This could result in the risk of fire or electric shock.
Caution – To prevent personal injury or damage to the product,
• Do not charge the shaver where the |
temperature is below 5°C (41°F) or |
above 35°C (95°F), where it will be |
exposed to direct sunlight or a heat |
source, or where there is a lot of |
moisture. |
• Use only the included adaptor |
ES8152 shaver. |
• Dry the shaver completely before |
charging it. |
• Keep the adaptor away from water |
and handle it only with dry hands. |
• The charge status lamp may not |
glow for several minutes after |
charging has commenced but will |
glow if charging is continued. |
• Grip the adaptor when disconnect- |
ing it from an AC outlet; tugging on |
the power cord may damage it. |
• Store the adaptor in a dry area |
where it will be protected from dam- |
age. |
• Do not pull, twist, or severely bend |
the power cord. |
• Do not wrap the power cord tightly |
around the appliance. |
• The linear motor of the shaver may |
start operating without the On/Off |
switch on if the shaver is placed |
near a television, stereo, audio- |
visual equipment or anything that |
generates strong magnetic field. |
that are designed for toilets, bath- rooms or kitchen appliances. Do not submerge the shaver for a long time.
•Do not wipe any part of the shaver with thinner, benzine or alcohol. Clean it by using a cloth dampened with soapy water.
•Do not take the housing apart as this can affect the watertight con- struction.
•Do not clean with water when the shaver is connected to the power cord.
•Do not shave when the “sonic” vi- bration is activated, as it may dam- age your skin.
•When cleaning the shaver with water, do so with both the inner blades attached. (Doing so with only one of the inner blades at- tached makes an abnormal noise and may damage the shaver.)
Specifications
Power source:
Motor voltage: 2.4 V DC
Charging time: 1 Hour
This product is intended for house- hold use only.
Do not place the shaver near these |
equipments. |
• Wash the shaver in tap water. Do |
not use salt water or boiling water. |
10Also, do not use cleaning products
FORYOUR CONVENIENCE, WE HAVE ESTABLISHED A
FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES MENTIONED ON THE BACK PAGE.
11
