At the same time, the “sonic” clean- ing symbol appears in the LCD display.
Pour some water over the outer foil. After about 20 seconds, it will be automatically turned off, or you can turn it off by pushing the On/Off switch.
Remove the system outer foil and push the On/Off switch more than 2 seconds to activate the turbo mode for “sonic” vibration cleaning and clean it with running water.
Wipe off any moisture from the shaver with a dry cloth and dry it with- out the system outer foil.
It is recommended to clean your shaver with the
Replacing shaving head components
It is recommended that you replace the system outer foil at least once a year and the inner blade at least once every 2 years to maintain your shav- er’s cutting performance.
Replacing the system outer foil (see fig. 20)
Squeeze the system outer foil re- lease buttons and lift the system outer foil upward to remove it. To in- sert the new system outer foil, press down until it snaps into place.
•Check that the gaps on both sides of the system outer foil release buttons and the system outer foil are equal. If they are not equal, there is a chance that the system
14
outer foil will become detached during use, or shaving capabilities will be deteriorated.
Replacing the inner blades (see fig. 21)
Squeeze the system outer foil re- lease buttons and lift the system outer foil upward to remove it. Re- move the inner blade one at a time by grasping it firmly at both ends and pulling straight away from the shaver. Do not touch the metal parts of inner blades.
To insert the new inner blade, hold the blade one at a time at both ends and press downward until it snaps into the shaver.
ATTENTION:
A
WARNING for Lithium Battery: Fire, explosion, and severe burn hazard.
Do not crush, disassemble, heat above 100°C (212°F), or incinerate.
How to remove the
(see fig. 22)
WARNING – Do not attempt to re- place the battery for the purpose of reusing the shaver. This could result in the risk of fire or electric shock.
The battery in this shaver is not in- tended to be replaced by consum- ers. However, the battery may be re- placed at an authorized service center. The procedure described be- low is intended only for removal of the rechargeable battery for the pur- pose of proper disposal.
1.Disconnect the power cord from the shaver when removing the battery.
2.Remove the bottom cover screw
(a).
3.Remove the bottom cover (b).
4.Slide the back panel (c) and re- move it.
5.Remove the housing clip (d).
6.Remove the four housing screws
(e).
7.Remove the housing B (f).
8.Lift the battery (g) and remove it.
Caution – To prevent personal injury or damage to the product,
•Do not charge the shaver, where it will be exposed to direct sunlight or a heat source, or where there is a lot of moisture.
•Use only the included adaptor RE-
•Dry the shaver completely before charging it.
•Keep the adaptor away from water and handle it only with dry hands.
•Grip the adaptor when disconnect- ing it from an AC outlet; tugging on the power cord may damage it.
•Do not pull, twist, or severely bend the power cord.
•Do not wrap the power cord tightly around the appliance.
•If the power cord gets damaged, it alone cannot be replaced. Contact an authorized service center.
•Store the adaptor in a dry area where it will be protected from dam- age.
•The shaver and adaptor will be- come slightly hot during use or charging, however this is not a malfunction.
•In cases where static noise is emit- ted from the television during use charging or cleaning, connect the adaptor to a different outlet.
•Do not touch the edge (metal part) of the inner blade.
Failure to observe this may lead to hand injuries.
•When the shaver is washed with- out the
•Do not wipe any part of the shaver with thinner, benzine or alcohol. Clean it by using a cloth dampened with soapy water.
•Do not take the housing apart as
this can affect the watertight con-
15struction.
