Before use
This Wet/Dry shaver can be used for wet shaving with shaving lather or for dry shaving. You can use this water- tight shaver in the shower and clean it in water. The following is the sym- bol of Wet shaver.The symbol means that
Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic Wet/ Dry shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method.
Parts identification 1
(see fig. 1)
AProtective cap
BSystem outer foil
CInner blades
DSystem outer foil release buttons
EPivot action selector
FFinger rest
GOn/Off switch
HLCD display
ITrimmer
JTrimmer handle
KAdaptor
LPower cord
MAppliance plug
N
Parts identification 2
(See fig. 2)
ODetergent cartridge
PWater tank
QSocket
RArm
SWater tank cap
TClean lamp
UDry lamp
VCharge lamp
wStatus lamp
xSelect button
YFeed water line
READ ALL INSTRUCTIONS BE- FORE USE.
Charging with self-clean- ing recharger
Before each use, ensure that the recharger unit is clean and dry. Thoroughly wipe off any water or moisture on or around the recharger unit.
1.Attach the detergent cartridge and the water tank securely to the
2.Insert the appliance plug into the socket (see fig.
3.Firmly insert the adaptor into the AC outlet (see fig.
It will be adjusted automatically to voltages between
In some areas, a special plug adaptor may be required.
4.Pull up the arm of the
5.Remove the protective cap and set the shaver firmly onto the self- cleaning recharger until it clicks (see fig.
•The
•Do not push the arm down- wards.
•Ensure that the outer foil does not get deformed or damaged when placing the shaver into the
Note
•Use the
•If it is far below or over the appro- priate temperature, the charging time may extend, or the
•In particular, low temperature may shorten the life span of the re- chargeable battery. In this case, the backlight of LCD display blinks twice in 1 second.
•When charging the shaver for the first time or when it has not been in use for more than 6 months, the plug symbol and backlight of LCD display may not illuminate for a few minutes after operation. These lights will eventually illuminate if kept connected.
When the shaver is being charged, the backlight of LCD display turns on, and the plug symbol appears (see fig. 4 (A)).
It shows the remaining battery capac- ity from 0% to 100%, in 10% incre- ments.
When the charging is completed, it will indicate “100%” and the backlight of LCD display will flash once in about 1 second. It will flash once in about 2 seconds for 10 minutes after charg- ing is completed (see fig. 4 (B)).
You can fully charge the shaver in 1 hour if the LCD display shows 10% and lower.
The plug symbol blinks in the LCD dis- play when the remaining battery ca- pacity is 10% and less.
The unit can be used once or twice more after the LCD display starts to show 10%. (Differs depending on the use situation.)
A full charge will supply enough power for approx. 14 shaves (3 min- utes per shave for a normal beard). You can always connect your shaver to the
Before travelling, charge it fully for 1 hour if you will not be taking the adap- tor with you.
Charging without self- cleaning recharger
Connect the power cord to the shaver, and plug the adaptor to an AC outlet (see fig. 5). The shaver will be adjusted automatically to voltages between
In some areas, a special plug adap- tor may be required.
8 | 9 |
