Cleaning with the self-cleaning recharger (continued)
Do the following if the status lamp blinks or glows during the “Clean/Dry/Charge” course or the “Clean/Dry” course.
Cleaning the shaver without the self-cleaning recharger
English
Blinks Correctly set the detergent cartridge and then restart a course.
If the status lamp
goes out Continue a course.
Glows
Remove the shaver from the
3 |
4 |
We recommend to clean your shaver with the 
appears in the LCD panel.
1. | Disconnect the power cord |
| from the shaver. |
2. | Apply some hand soap to the |
| outer foil. |
3. | Press the On/Off switch for |
| more than 2 seconds to |
| activate the turbo mode for |
When an abnormality has
been corrected
Press and hold [SELECT] for approximately 2 seconds to turn off the status lamp and then restart a course.
When no abnormality was
found
It is time to replace the detergent cartridge and cleaning liquid inside the water tank.
Drain the old cleaning liquid inside the water tank and then refill it with water. Replace the old detergent cartridge and then restart the course.
6 |
“sonic” vibration cleaning. |
• appears in the LCD panel. |
• After about 20 seconds, it will |
be automatically turned off, |
or you can turn it off by |
pressing the On/Off switch. |
4. Remove the system outer foil |
and press the On/Off switch |
for more than 2 seconds to |
activate the turbo mode for |
“sonic” vibration cleaning and |
clean it with running water. |
5. Wipe off any drops of water |
with a dry cloth. |
When the status lamp goes |
| When the status lamp glows |
out |
| again |
Continue a course. |
| Contact an authorized service |
|
| center. |
| ||
|
|
|
6. Remove the system outer foil |
to allow it to dry completely. |
9
