Such preventive safety measures reduce the risk of starting the tool acci- dentally.
16)Store idle tools out of reach of chil- dren and other untrained persons. Tools are dangerous in the hands of untrained users.
17)When battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another.
Shorting the battery terminals together may cause sparks, burns or a fire.
18)Maintain tools with care. Keep cut- ting tools sharp and clean.
Properly maintained tools with sharp cutting edge are less likely to bind and are easier to control.
19)Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tool’s operations. If damaged, have the tool serviced before using.
Many accidents are caused by poorly maintained tools.
20)Use only accessories that are recom- mended by the manufacturer for your model.
Accessories that may be suitable for one tool may create a risk of injury when used on another tool.
Service
21)Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel may result in a risk of injury.
22)When servicing a tool, use only identical replacement parts. Follow instructions in the Maintenance section of this manual.
Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of shock or injury.
.SPECIFIC SAFETY RULES
1)Hold tool by insulated gripping sur- faces when performing an opera- tion where the cutting tool may con- tact hidden wiring.
Contact with a “live” wire will also make exposed metal parts of the tool “live” and shock the operator.
2)Wear ear protectors when using the tool for extended periods. Prolonged exposure to high intensity noise can cause hearing loss.
3)Be aware that this tool is always in an operating condition, it does not have to be plugged into an electrical outlet.
4)Do not operate the Forward/Reverse lever when the Variable speed con- trol trigger is on.
The battery will discharge rapidly and damage to the unit may occur.
5)If the bit becomes jammed, imme- diately turn the Variable speed con- trol trigger off to prevent an overload which can damage the battery pack or motor. Use reverse motion to loosen jammed bits.
6)When storing or carrying the tool, set the Forward/Reverse lever to the center (switch lock) position.
7)Do not strain the tool by holding the speed control trigger halfway (speed control mode) so that the motor stops.
8)During charging, the charger may become slightly warm. This is nor- mal. Do not charge the battery for a long period.
Symbol | Meaning | |||||||
|
| V | Volts | |||||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Direct Current | |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
|
| n0 | no load speed | |||||
|
|
|
|
|
|
|
| |
…/min | revolutions or | |||||||
reciprocation per minutes | ||||||||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| Forward Rotation | |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| Reverse Rotation | |
|
|
|
|
|
|
|
| |
- 3 -
