![](/images/new-backgrounds/1151210/1512109x1.webp)
■HOW TO DISASSEMBLE THE GEAR BOX BLOCK.
Ref. No. 2C | Procedure 2A → 2B → 2C | Removal of the gear box block. | |
|
| 1. | Loosen 8 screws of the gear case. |
|
| 2. | Take out a steel ball pushing the chuck spring with the chuck |
|
| spring plate. | |
|
| 3. | Remove the chuck spring, the chuck spring plate and the spindle |
|
| & piston assembly. | |
|
| 4. | Remove the intermediate shaft assembly. |
For assembling
NOTE :
Every time the gear box block is opened, use the new gaskets and screws.
1. Assemble the bearing with the spindle assembly.
2. Fit
3. Assemble the chuck spring and the chuck spring plate.
4. Insert a ball pushing down the chuck spring.
5.Insert the reciprocation bearing shaft into the hole of universal coupling. Make sure two thrust plates should be set both side of reciprocation bearing shaft one of each.
NOTE :
Greasing about 30g into the gear box block especially for the connection area between reciprocation bearing and universal coupling. In addition, hammer
Air compressed by the piston drives hammer. Take care to protect the piston and hammer from contamination by dust.
5