Panasonic EY6813 Operation, Chuck, Foward/Reverse lever, Variable speed control trigger

. Operation

Chuck

Note: Grease for bit

Grease the oval indentation on the bit with the supplied grease at least once a month.

1. To mount the bit

1-1. Insert a bit into the mounting hole, and turn it slightly to locate an en- gaged position.

1-2. At the engaged position, push the bit as far as it goes. Make sure that the bit is fixed by pulling it.

2. To dismount the bit

2-1. Depress the chuck cover and pull the bit.

Foward/Reverse lever

ForwardReverse

Be sure to set the switch in the cen- ter to lock it after use.

Operate the Forward /Reverse lever after the motor rotation is complete- ly stopped.

Hammering/drilling switching lever

Speed/Blow Mode selection lever

1.There are four modes available with the combination of Hammering/ drilling switching lever and Speed/ Blow Mode selection lever.

Select the suitable mode for appli- cation.

2.Operate the mode change after the motor rotation is completely stopped.

Position of	Speed/Blow Mode	Recommended
switching
	selection lever	application
lever
	Hard blow hammer-	This mode has hard
	ing mode	blow hammering which
		is suitable for concrete
		drilling.
		Concrete drill
(Rotation with	Soft blow hammering	This mode is suitable
	mode	for concrete drilling
hammering)		with smaller diameter
		drill, or for drilling into
		soft base material.
		Small diameter con-
		crete drill
	High speed drilling mode	This mode is suitable
		for metal drilling with
		high speed rotation.
		Metal drill
		Metal hole saw
(Rotation only)	Slow speed drilling mode	This mode is suitable
		for wood drill with high
		torque.
		Wood drill

Variable speed control trigger

To set the center of a hole, pull the trigger slightly to start the drill rotation slowly.

- 7 -