Panasonic FV-11VHL2, FV-11VH2 manual White to white Junction box Conduit Circular duct Fan body

INSTALLATION (JOIST MOUNTING- ) CONTINUED

5.Remove the lighting cord out from hook (FV-11VHL2), then remove junction box plate and secure conduit or stress relief to wiring box knock-out hole.(Fig.5)

6.Refer to wiring diagram (Page.5)

Follow all the local electrical safety codes. As well as the National Electrical Code (NEC).

Using UL approved wire nuts, connect house power wires to ventilating fan wires (Fig.6):

Black to black; white to white; green to green. Make sure all connections are fastened firmly after wiring is finished.

Replace the junction box plate, and then replace lighting cord to hook. (Fig.5)

Lighting cord	Screw driver
	Junction box
	plate
Hook	Screw
	Fig.5
Black to black	White to white
Junction box plate White to white	Black to black
	Green to green
	Wire nut
Black to black	Black to black
White to white	Junction box
	Conduit
	Fig.6
Conduit	Circular duct
Fan body	Duct tape
	or clamps
Joist

7.Install the circular duct (4 inches) to the adaptor and secure it with duct tape or clamps. (Fig.7)

8.Finish ceiling work. Ceiling hole should be aligned with the edge of the flange. (Fig.8)

9. Install the fluorescent lamps and then install the night lamp. (Fig.8)

10.Insert mounting springs into slots as shown and mount grille to fan body. (Fig.9)

Note:Do not mount grille and springs conversely. If the grille is mounted in the opposite direction, the grille can not be fitted to the ceiling, so then reverse the grille position and try to mount again.

4 Long screws (ST4.2X20)								Fig.7
	17 3/8 (441)
							19	)
					(	3
				/8
Night lamp		2	5
	1
								Fig.8
	Fluorescent lamp
Slot	Mounting spring
Correct
Incorrect
	Grille							Fig.9
	Switch							Switch
	labels							labels

(Fig.10) Fig.10

For Model FV-11VHL2 For Model FV-11VH2