[QUICK START]

[OFF]/[ON]

This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is reopened.

Quick start will not work if there is no SD card inserted.

Quick start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there is no SD card inserted.

Change the mode to .
1Set [QUICK START] to [ON].2Close the LCD monitor while the mode is set to

.

The status indicator A flashes green and the unit goes into quick start standby mode.

3 Open the LCD monitor.

The status indicator A lights red and the unit is put into recording pause.

When in quick start standby mode about 60% of the power used in recording pause mode is being consumed, so the recording time will be reduced.

Quick start standby mode is cancelled if jabout 5 minutes elapsed

jmode is set to

It may take some time for automatic white balance to adjust.

In the quick start mode, the zoom magnification becomes 1k.

If [ECONOMY] (l 30) is set to [5 MINUTES] and the unit automatically goes into quick start standby mode, close the LCD monitor and then open it again.

Turn the unit off using the power button.

[ALERT SOUND][OFF]/ /

Start and stop of recording and unit on/off can be confirmed with this sound.

(Volume low)/ (Volume high)

2 Beeps for 4 times

When an error occurs. Check the sentence displayed on the screen. (l 90)

- 31 -