Setup

TAD/FAX mode

(using the built-in answering device and receiving voice and fax calls automatically)

When you turn on AUTO ANSWER (the pre-selected setting is TAD/FAX), the unit will work as a fax machine and/or answering device.

If a fax call is detected, the unit will automatically switch to receive faxes.

If a voice call is detected, the answering device will begin recording and the caller can leave a voice message.

●You can use a pre-recorded greeting message (p. 85) or record your own greeting message (p. 86).

Setting the unit to receive voice messages and documents and checking your greeting message

If the AUTO ANSWER light is off, turn it on by pressing

AUTO ANSWER .

Display: TAD/FAX MODE

●If the display shows “TEL/FAX MODE” or “FAX ONLY MODE”, set the unit to “TAD/FAX MODE” (p. 67).

●The unit will play the TAD/FAX greeting message and the remaining time for recording incoming messages will be displayed.

AUTO ANSWER

TAD/FAX ON

ON

Example: TIME = 10m13s

Note:

1 2 3

4 5 6

7 8 9

0

●Each incoming message recording time can be set. To change the setting, see page 102.

●For the total recording time (including the greeting messages), see “Memory Capacity” on page 123.

●When the remaining time is low, erase unnecessary messages from memory (p. 90, 96).

●While an incoming call is being recorded, you can monitor it through the speaker. If this feature is not required, set the ICM monitor feature to “OFF” (p. 103).

84