IP Proprietary Telephone
Quick Reference Guide
Model No.
Important Information
When using the
•If the unit does not operate properly, disconnect the unit from the Ethernet® cable and then connect again.
•If you are having problems making calls, unplug the Ethernet cable and connect a known working IP Proprietary Telephone
•Wipe the unit with a soft cloth. Do not clean the unit with abrasive powders or with chemical agents such as benzene or thinner.
•Use only the correct Panasonic handset.
•Do not disassemble this unit. Dangerous electrical shock could result. The unit must only be disassembled and repaired by qualified service technicians.
•If damage to the unit exposes any internal parts, immediately disconnect the cable or cord. If the power is supplied from the network to the
•Never attempt to insert wires, pins, etc. into the vents or other holes of this unit.
Take special care to follow the safety suggestions listed below. Safety
1)The unit should only be connected to a power supply of the type described in the Quick Reference Guide or as shown on the label on the unit.
2)When left unused for a long period of time, the optional AC adaptor should be unplugged from the AC outlet, if you are using
Installation
Environment
1)Do not use this unit near water, for example, near a bathtub, washbowl or sink. Damp basements should also be avoided.
2)Keep the unit away from heating appliances and devices that generate electrical noise, such as fluorescent lamps, motors and televisions. These noise sources can interfere with the performance of the unit. It also should not be placed in rooms where the temperature is less than 5 °C (41 °F) or greater than 40 °C (104 °F). Allow 10 cm (4 in) clearance around the unit for proper ventilation.
Placement
1)Do not place heavy objects on top of this unit.
2)Care should be taken so that objects do not fall onto, and liquids are not spilled into, the unit. Do not subject this unit to excessive smoke, dust, moisture, mechanical vibration, shock or direct sunlight.
3)Place the unit on a flat surface.
Trademark:
Ethernet is either a registered trademark or a trademark of Xerox Corporation in the United States and/or other countries.
Document Version:
