1. Introduction
2. Installation
Names and functions
Motor Nameplate
Frame
Wiring
nameplate
Earth ground terminal
M4 x 6 stainless steel
with spring and flat washer
Capacitor cap
#187
Quick connect tab (Faston)
Capacitor
Motor accessories (only for single phase version)
*Don't remove the nameplate.
Gear head nameplate |
|
O ring | Oil seal |
Bracket |
|
| Key |
Oil seal |
|
Output shaft
Shaft
Screw | Flat washer | Nut |
Gear head accessories
Motor
Installation location
Install the motor as described to prolong the motor lifetime in a place where;
(1)is free from rain and direct sunlight.
(2)is free from vibration 4.9 m/s2 or more; shock, dust, iron powder or oil mist; splash of water. oil and grinding fluid; and away from flammable materials, corrosive gas (H2S, SO2, NO2, Cl2, etc.) or flammable gas.
(3)is enough ventilated dry and clean keeping oil, water, dust and heat away.
(4)you can check and clean the motor easily.
(5)is not in a closed environment where the motor temperature may increase. This may result in the motor life shortened.
Environmental condition
Item | Description |
Ambient temperature | |
Ambient humidity | 85% RH or below (no dewing) |
|
|
Storage temperature | |
Vibration | 4.9 m/s2 or below (10 to 60 Hz) |
Altitude | Lower than 1000 m. |
|
|
*1) Measurement taken at a point 5 cm from the motor.
*2) Allowable range for a relatively short period, for example, during transportation.
Installation
The motor can be installed vertically or horizontally but leadwires should be directed downward.
Keep the motor away from oil, water and dust
(1) Don't run the cable in water or oil. |
|
(2) Don't expose the motor to splashing oil or | Motor |
water.
Cable
Oil, water
English
Ð 8 Ð | Ð 9 Ð |