3.6.1 | Counting rising edges using the event count | 37 |
3.6.2 | Setting timer output pin | 44 |
3.6.3 | 50 kHz signal output using the timer output | 47 |
3.6.4Interrupt generation every 100 milli seconds using the cascade connection of
timer 0 and timer 1 | 52 |
3.6.5Interrupt generation every 60 seconds using the cascade connection of timer 0,
| timer 1, timer 2 and timer 3 | 59 |
3.7 | 68 | |
3.7.1 | Counting rising edges using the event count | 75 |
3.7.2 | Setting timer output pin | 79 |
3.7.3 | 50 Hz signal output using the timer output | 81 |
3.7.4 | 1/4 duty waveform output using the timer output | 85 |
3.7.5 | Pulse width measurement using the timer capture function | 89 |
3.7.6 | Up/down counting selection with TM8AIO (external trigger) | 93 |
3.7.7 | Counting operation with | 97 |
3.7.8 | Count disable with TM8AIO (external trigger) | 103 |
3.7.9 | Timer | 107 |
3.7.10 | Timer activation with TM8AIO (external trigger) | 111 |
3.8 | Synchronous serial interface operation | 115 |
3.8.1 | Setting serial transmission pin | 115 |
3.8.2 | Setting serial reception pin | 122 |
3.8.3 | Transmitting data with no start condition | 128 |
3.8.4 | Transmitting and receiving data with no start condition | 137 |
3.8.5 | Receiving data with no start condition | 146 |
3.9 | A/D conversion function | 154 |
3.9.1 | Setting analog input pin | 154 |
3.9.2 | A/D conversion of single channel | 157 |
3.9.3 | A/D conversion of multiple channels | 163 |
3.9.4 | A/D conversion of multiple channels using control register B | 171 |
3.10 | Motor control | 181 |
3.10.1 | Setting motor control PWM output pin | 187 |
3.10.2 | 189 | |
3.10.3 | Deadtime insertion | 193 |
3.11 | Notes for | 197 |
3.11.1 | 198 | |
Chapter 4 Microcomputer Basics 2 |
| |
4.1 | Chapter overview | 2 |
Table of Contents 3
