Installation / How to replace room lamp Preparations
Installation
• The refrigerator must be located in the place where there is good air circulation. There should be a space between the top of the refrigerator and the ceiling at least 30 cm as well as the space between the back of the refrigerator at least 10 cm and the side of the refrigerator and the wall at least 5 cm.
• Do not locate the refrigerator in a humid place as rust may form and may cause electric leakage.
•Do not locate the refrigerator exposing to direct sunlight as the heat and sunlight will increase the temperature.
•When moving or shifting the refrigerator, remove all trays and check to be sure that there is no water in the refrigerator.
•In case of placing the refrigerator on an uneven
surface, adjust the leveling stand to make the refrigerator stands stably.
•If there is no ground wiring plug in refrigerator, it should be connected with ground connection to prevent hazard from electric leakage.
30 cm
5 cm
10 cm
How to use
How to replace room lamp
When replace room lamp, shall be disconnect supply cord to prevent electric shock.
1.Disconnect supply cord.
2.Remove room lamp cover from back
side (following picture | ) |
3.Replace proper lamp (E14 240V 15W max.) surely.
4.When finish replacing room lamp, assembly room lamp cover by reverse proper method.
use your finger to push the back locking tab to unlock room lamp cover
room lamp cover
Remark
1.Be careful while replacing a room lamp, you may get injured from touching a hot lamp.
2.Do not press front side when removing room lamp cover.
7
1/12/10 7:13:56 PM |
