Installation
The distance from the wall is installed
The top of the refrigerator and the ceiling at least 30 cm.
The wall and the back of the refrigerator at least 10 cm. The side of the refrigerator and the wall at least 5 cm.
Area around installed
Do not locate the refrigerator in a humid place as rust may form and may cause electric leakage.
Do not locate the refrigerator exposing to direct sunlight as the
heat and sunlight will increase the temperature. | 5 cm |
Do not block the openings on the circumstances of the refrigerator.
The refrigerator must be located in the place where there is good air circulation.
In case of placing the refrigerator on an uneven surface, adjust the adjuster bolt to make the refrigerator stands stably.
Moving or shifting
When moving or shifting the refrigerator, remove ice tray, ice box, pan water evap etc. and check to be sure that there is no water in the refrigerator.
30 cm
10 cm
LED lamp and Grounding
The refrigerator LED lamp, specially designed for this refrigerator, does not function on individual replacing. If you need replacement, please contact Panasonic Service Center.
If there is no grounding wiring plug in refrigerator, it should be connected with grounding connection to prevent electrical hazard.
For safety, the grounding connection should be done
(For a refrigerator with plug
The grounding connection will allow prevention of danger resulted from electricity leakage. The grounding connection can be performed in 2 ways as follows:
1.In the case that the grounding receptacle having been prepared for the socket (plug socket), connect the grounding wire to the screw used for grounding connection at the bottom rear of the refrigerator (regarding the screw used for grounding connection, please notice the symbol) as shown in the illustration 1.
2.In the case that the socket (plug socket) having not been provided with any grounding receptacle, connect the grounding wire to the screw at the bottom of the refrigerator, (as regards the screw used for grounding connection, please notice the symbol). And then connect the other end to the grounding rod as shown in the illustration 2.
1
Grounding receptacle
2
Grounding wire
Illustration for the grounding connection
Prohibited spots for grounding connection
Gas pipes and water supply pipes (dangers from electric shock or explosion).
The grounding wires of telephone cords and lightning rods (dangers from lighting).
4
28/5/2554 10:12:45