9

ªInserting a Button-type Battery

Before using the Remote Controller, insert the supplied button-type
battery.
1While pressing the Stopper 1, pull out the Battery
Holder.
2Insert the button-type battery with the imprint (i)
facing upward.
3Insert the Battery Holder into the Remote Controller.
When the button-type battery is weak, replace it with a new
CR2025 battery. (A battery is normally expected to last about
1 year. However, it depends on operation frequency.)
Make sure to match the poles correctly when inserting the battery.
.........................................................................................................
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the
equipment manufacturer. Discard used batteries according to
manufacturer’s instructions.
.........................................................................................................
WARNING
Risk of fire, explosion and burns. Do not recharge,
disassemble, heat above 100xC or incinerate. Keep the
Button-Type battery out of the reach of children. Never put
Button-Type battery in mouth. If swallowed call your doctor.
.........................................................................................................

ªUsing the Remote Controller

1

11
1Direct the Remote Controller to the Remote Control
Sensor of the Movie Camera and press an
appropriate button.
Distance from the Movie Camera: Within approximately
5 metres
Angle: Within approximately 15o in the vertical and horizontal
directions from the central axis
The above operating ranges are for indoor use. Outdoors or under
strong light, the Movie Camera may not operate properly even
within the above ranges.
For other notes concerning this item, see page 46.
1
3
2
1
15˚
15˚
15˚
15˚