10
Power SupplyªUsing the AC Adaptor
1Connect the DC Input Lead to the [DC IN] Socket on
the Movie Camera.
2Connect the DC Input Lead to the AC Adaptor.
3Connect the AC Mains Lead to the AC Adaptor and
the AC mains socket.
≥The AC Mains Lead’s outlet plug cannot be pushed fully into
the AC Adaptor socket. A gap will remain as shown 1.
≥Before connecting or disconnecting the power supply, set the
[VCR/OFF/CAMERA/M-CARD] Switch on the Movie Camera to
[OFF] and make sure that the [POWER] Lamp is not lit.
ªUsing the Battery
Before use, fully charge the Battery.
1
11
1Attach the Battery to AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Input Lead
is connected to the AC Adaptor, disconnect them.
≥The [POWER] Lamp and [CHARGE] Lamp lights up, and
charging starts.
≥When the [CHARGE] Lamp goes off, charging is completed.
2
22
2Attach the charged Battery to the Movie Camera.
To Remove the Battery
Set the [VCR/OFF/CAMERA/M-CARD] Switch 2 to [OFF], and
while pressing the [BATT RELEASE] Lever 3, slide the Battery to
remove it.
≥When attaching or removing Battery, set the [VCR/OFF/
CAMERA/M-CARD] Switch to [OFF] and make sure the
[POWER] Lamp is not lit.
ªUsing the Car Battery Charger
If you use the Car Battery Charger (VW-KBD2E; optional), you can
supply power to the Movie Camera and charge the battery inside
your car. For further information, refer to the instruction manual of
the Car Battery Charger.
≥Be sure to start the car engine before you connect the Car Adaptor
Cord, otherwise the fuse may blow.
≥For other notes concerning this item, see page 46.
3
2
1
1
3
2
BATT RELEASE
VCR
OFF
CAMERA
M-CARD