Getting Started
RQTV0115 99
Before Use

Connections

When the unit is turned on after connecting the aerial cable and the mains lead, Plug in Auto Tuning starts automatically.

Basic Connections

The following connections are required to record on a
video cassette and playback a video cassette/discs
through the TV.
≥Refer to the TV’s operating instructions.
≥Turn the TV off and disconnect its AC mains lead.
Note:
The included AC mains lead are for use with this unit
only. Do not use them with other equipment.
ªFor NV-VP60GC
2 AC mains leads are supplied for this unit. Use one of
the supplied AC mains leads of which the plug fits into
your outlet.
3 pin mains plug is for Saudi Arabia.
TV Set (Not supplied)
Aerial
(Not supplied)
Aerial Connector
To mains supply
AUDIO
IN
LR
VIDEO
IN
S-VIDEO
IN
COMPONENT
VIDEO IN
YPBPR
AUDIO IN
LR
R-AUDIO-L
COAXIAL
S- VIDEO
VIDEO OUT
(480P/480I)
Television

Audio/Video Output Sockets

COMPONENT VIDEO terminal (progressive out)

These terminals can be used for either interlace or progressive
output and provide a clearer picture than the S-VIDEO terminal.
Connection using these terminals outputs the colour difference
signals (PB/PR) and luminance signal (Y) separately in order to
achieve high fidelity in reproducing colours.
≥The description of the component video input terminals
depends on the TV or monitor (e.g. Y/PB/PR, Y/B-Y/R-Y, Y/CB/
CR). Connect to terminals of the same colour.
Video cable (Not supplied)
Television

For Better Video from DVD

≥These connections are for the DVD section only.
Carry out the Basic Connections described above to view video from
the VHS section.
≥When making this connection, ensure that you connect the Audio
cables (not supplied) to the corresponding audio input terminals on
the TV.
≥You may need to change the video-input mode on the TV to view
video from the VHS and DVD sections. Read your TV’s operating
instructions for details.
S-Video cable (Not supplied)

S-VIDEO terminal

The S-VIDEO terminal achieves a more vivid
picture than the VIDEO OUT terminal by
separating the chrominance (C) and luminance
(Y) signals (Actual results depend on the TV).
≥Connect to a different terminal group (e.g.
“VIDEO 2”) than that you used for the
connection through this unit’s VHS/DVD OUT
terminal. Picture from the VHS section will not
appear when you use the same group input
terminal connections because the S-Video
terminal input takes precedence.
Television
≥Set the RF output channel of the unit to “ss”
(RF OFF) (l12).
≥Connect Audio/Video cables directly to your TV.
The video signals on DVDs and video tapes
have copyright protection. The video may not be
shown correctly if you connect through an A/V
selector or other equipment. Audio/Video cable
(Supplied)
Television
Audio cable
(Not supplied)
VP60GCS.book Page 9 Monday, March 6, 2006 3:23 PM