About Your Projector
ENGLISH - 13
Preparation
J

Back and bottom view

NOTE:
Do not cover the ventilation openings or place anything within 10 cm (4") of the vents as this may cause
damage or injury.
This projector should only be used with the attached Power cord to ensure optimum performance and avoid
damage to the projector.
Connect an RS-232C
compatible cable for
controlling the projector
remotely via your PC.
SERIAL
Connect an RGB signal cable
from your PC.
PC IN
Connect a YPBPR signal
cable.
COMPONENT IN
Connect a S-VIDEO signal
cable.
S-VIDEO IN
Connect an HDMI signal
cable.
HDMI IN
Security lock
Attach the commercial shackle
lock, manufactured by
Kensington, to protect your
projector. Compatible with the
Kesington MicroSaver
Security System.
Lamp unit component
Houses the replaceable lamp
unit. Contact the projector
dealer or an authorized
service center for
replacement. (page37)
Front leg adjuster (L/R)
Screw up/down to adjust the
projection angle. (page15)
COMPONENT IN
VIDEO IN
Connect an RCA composite
video cable.
AC IN
Connect the Power cord to
supply electronic power to the
projector. (page 26)
MAIN POWER
Switch the projector on/off.
(page 19)

Connecting

terminals

Air intake port
Intake fresh air to control the
temperature inside.