Panasonic PT-AX100U Temp and Lamp Indicators, Controlling alerts, Lamp indicator Temp indicator

Maintenance

TEMP and LAMP Indicators

Controlling alerts

If a problem should occur with the projector, the TEMP and/or LAMP indicators will alert you. Respond to the alert as follows.

1.Confirm the POWER indicator status and turn off the projector in the proper way.

2.Find out the cause of the problem.

3.Follow the instructions for each indication below and solve the problem.

4.Turn on the projector in the correct way and confirm the indicator is not indicating a problem any longer.

NOTE:

If no problem is found or the problem remains, do not turn on the projector. Instead contact an Authorized Service Center.

LAMP indicator

TEMP indicator

TEMP indicator

Indicator and	Illuminating RED and still projecting
projector	Flashing RED and POWER is turned off
Problem	The temperature inside and/or outside the projector is abnormally high.
Cause	The ventilation ports are	The room temperature is too		The Air filter is excessively
	covered.	high.		dirty and the ventilation is
				poor.
	Remove the object(s) from	Reinstall the projector at a		Clean or replace the Air filter
				in the proper way. See
Remedy	the ventilation ports or clear	temperature controlled place.
				“Cleaning the Air filter” on
	around the projector.	See “Setting up” on page 14.		page 37.
LAMP indicator
Indicator	Illuminating RED		Flashing RED
Problem	LAMP RUNTIME has reached 1 800 hours		LAMP circuit failure or abnormal function.
	(with LAMP POWER set to NORMAL).
Cause	Lamp unit will run out soon and needs to be		The projector is switched off incorrectly.
	replaced.
			Let the LAMP cool down and turn on the
Remedy	Replace the Lamp unit. See “Before		projector.
	replacing the Lamp unit” on page 38.		If the POWER does not turn on, contact an
			Authorized Service Center.

36 - ENGLISH