Switching the projector on/off
Mains lead
Connecting
1.Make sure the shape of the mains plug and
the AC IN connector on the back of the
projector match, then
push the plug all the way in.
2. Connect the Mains lead to a mains socket.
Disconnecting
1.Make sure the MAIN POWER is switched off and unplug the Mains lead from the mains socket.
2.Hold the plug and unplug the Mains lead from the AC IN connector on the back of the projector.
Direct power off function
You can disconnect the Mains lead from the projector or switch off the MAIN POWER button while projecting or soon after projecting. The internal lamp cooling fan will keep operating by the internal power supply.
NOTE:
•If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, it may take a while to start the projection.
Direct power on function
If you activate the DIRECT POWER ON, you can start the projection only with connecting the Mains lead or switching on the MAIN POWER. See “DIRECT POWER ON” on page 37.
Basic Operation
NOTE:
•Do not use other than a provided Mains lead.
•Ensure all the input devices are connected and turned off before connecting the Mains lead.
•Do not force the connector as this may damage the projector and/or the mains lead.
•Dirt or dust
•Switch off the power to the projector when not in use.
POWER indicator
POWER indicator
Indicator status | Status | ||
|
|
| |
No illumination or flashing | The MAIN POWER is switched off. | ||
|
|
| |
|
| The MAIN POWER is switched on and the projector is in standby. | |
| Lit | When the LAMP or TEMP indicator is flashing, the POWER indicator will | |
RED |
| not be lit. | |
| Flashing | Network connection is ready while the POWER is turned off. | |
| |||
|
| ||
|
|
| |
GREEN | Flashing | The POWER is switched on and the projector is getting ready to project. | |
|
| ||
Lit | The projector is ready to project. | ||
| |||
|
|
| |
| Lit | The POWER is switched off and the projector is cooling the lamp. | |
ORANGE |
|
| |
Flashing | The POWER is switched on again when cooling the lamp and recovering | ||
| |||
| to projection mode. Recovery may take a while. | ||
|
| ||
|
|
| |
NOTE:
•If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, it may take a while to start the projection.
•The electric consumption in standby mode is 3 W.
