Before using
14
LSQT0860
Power supplyªCharging the battery
When this product is purchased, the battery is not
charged. Charge the battery before using this
product.
≥Battery charging time (-15-)
≥We recommend using Panasonic batteries.
≥If you use other batteries, we cannot guarantee
the quality of this product.
≥If the DC input lead is connected to the AC
adaptor, then the battery will not charge.
Remove the DC input lead from the AC adaptor.
1Connect the AC cable to the AC adaptor and
the AC jack.
2Put the battery on the battery mount by
aligning the mark, and then securely plug it
in.
ªCharging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the [CHARGE]
lamp flashes and the charging time will
be longer than normal.
ªConnecting to the AC outlet
1Connect the AC cable to the AC adaptor and
the AC jack.
2Connect the DC cable to the AC adaptor.
3Connect the DC cable to this product.
≥The output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in 1, there is a gap.
≥Do not use the power cord for other
equipment since the power cord is exclusively
designed for this Camcorder. Do not use the
power cord from other equipment for this
Camcorder.
ªFitting the battery
Push the battery against the battery holder and
slide it until it clicks.
ªRemoving the battery
While pushing the [PUSH BATT] button, slide the
battery (or the DC input lead) to remove it.
≥Hold the battery with your hand so it does not
fall.
1
PUSH
BATT
LSQT0860ENG.book 14 ページ ２００４年１２月２２日 水曜日 午後２時３８分