21
Basic Operation
Playing Back Recordings
Connections 1Set POWER to:
VCR ➞view playback.
CAMERA ➞view picture as it is
recorded.
2Turn TV ON and set to LINE INPUT.
See TV owner’s manual.
3Begin playback or recording.
Audio/
Video Out
CATV System Installer
This reminder is provided to call the CATV system installer’s attention to Article 820-40
of the NEC in USA (and to the Canadian Electrical Code in Canada) that provides
guidelines for proper grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building, as close to the point of cable
entry as practical.
Connect Camcorder to a TV to view
playback or recordings in progress.
Before you begin...
• Connect Camcorder to power source.
• Make all TV-Camcorder connections.
To Video
In
To Audio
In
Audio/Video Cable
(Supplied)
T V
TV Playback or Viewing
Remove Battery lid
and insert AA
battery.
• Do not reverse
polarity.
• Replace battery
when tape loading/unloading takes
longer than usual.
aTurn cassette
Tape Wheel in
direction of arrow to
take up any slack.
bSlide RELEASE to
open cassette lid.
cInsert the
cassette with the
window up and on the
left, then snap lid shut.
Remove Cassette
Insert Cassette in PlayPak
aSlide RELEASE
and wait for lid to
open.
bPush cassette
out through
hole in bottom of
PlayPak with
your finger.
• Do not obstruct cassette reel while loading.
• Allow PlayPak Load Detector to fully retract before
using in VHS VCR.
Load Detector