9
Getting Started
BATTERY
PACK
Supplying Power
To use battery refresh, insert Battery on AC
Adaptor (see steps 1~2 above), then press
BATTERY REFRESH.
The REFRESH Lamp lights, then goes out when
discharge is complete. Battery charging will then
start automatically.
If BATTERY REFRESH is pressed by mistake,
remove Battery from AC Adaptor and reinsert it
for normal charging.
Note:
• Charging takes about 7 and 1/2 hours when
Battery Refresh is used.
• Battery will not operate in extremely high
temperatures.
BATTERY
REFRESH
Note:
• Charging takes about 1 and 1/2 hours.
• While the DC Power Cable (supplied) is connected
to the AC Adaptor, the Battery cannot be charged.
• After charging 5 times, use Battery Refresh feature
as explained below.
• Battery life gradually decreases after repeated use
and recharging. If operation time becomes very
short even after a sufficient charge, discard Battery
properly (page 10).
Charge Battery Pack fully before use.
POWER
Lamp
CHARGE
Lamp
1Plug in AC Adaptor.
POWER Lamp lights.
2Insert Battery.
AAlign left side of Battery with left edge of
AC Adaptor.
BPress Battery down and slide in direction
of arrow.
The CHARGE Lamp flashes, then stays lit
when charging is complete.
3Remove Battery.
Slide Battery to the left and lift off.
1
23
BATTERY
PACK
Charging the Battery Pack
Battery Refresh
This feature completely discharges
Battery before recharging begins.
Use after every 5 charges for optimum
Battery performance.
A fully charged Battery provides a maximum of about 2 hours of continuous use (LCD
monitor off) or about 1.5 hours (LCD monitor on). Actual time may vary due to operating
conditions. Using the Built-in Light decreases operating time.
Using the Battery Pack
A
Attach Battery.
aInsert top of Battery into top of mounting
surface.
bPress and snap into place.
B
Remove Battery.
Slide BATTERY RELEASE and remove
Battery.
b
A
B
BATTERY
PACK
A
REFRESH
Lamp
BATTERY
PACK
a
(Top View)
B