Panasonic PV C2063 operating instructions Manual Clock Set, Reset all unit Memory Functions

*Important: If a remote control button does not work when pressed, press the COMBO button on the remote and try the button again.

Manual Clock Set

If AUTO CLOCK SET was incomplete, manually set the clock as follows.

Press ACTION on the remote to display

1 SET CLOCK Menu screen.

		SET CLOCK
1 /	/	:
			DST : ON
SELECT :			SET :
END		: ACT I ON

Press to select the month and

2 press to set. In the same manner, select and set the date, year, time, and DST. (Daylight Saving Time)

SET CLOCK

2 / 6 / 2003 THU 12:00PM

DST : ON

SET COMPLETED

SET	:
START	: ACT I ON

Press ACTION twice to start CLOCK and

3 exit.

POWER
	SELECT/SET
	:CH UP
ACTION	:CH DOWN
	:VOL UP
	:VOL DOWN

Reset all unit Memory Functions

When moving unit to a new location, or if a mistake was made in the Initial Setup section.

• Make sure a tape is not inserted in the unit.

POWER VOL CH STOP/EJECT REW/ PLAY/REPEAT FF/ REC TIMER/FM

1 Turn the unit Power on.

2 Press and hold both PLAY/REPEAT and FF on the unit for more than 5 seconds.

•The power will shut off.

•Please ignore “NO CASSETTE” warning.

3 Do “Initial Setup” on page 8.

Note to CABLE System Installer

This reminder is provided to call the CABLE (Cable TV) System Installers attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Initial Setup

9