Recording
You can record radio broadcasts or CDs.
Before recording
•This unit is suitable for recording normal tapes, but it cannot record onto high and metal position tapes to their full potential and prior
recordings will not be erased correctly.
• The recording level is set automatically.
• Take up the leader tape before proceeding.
Leader tape (Recording cannot be made.) 
1 3
To stop recording
Press [ 
/ 
STOP/EJECT ]. (The CD does not stop.)
To stop recording temporarily
Press [ 
PAUSE ]. (The CD does not stop.)
Press once again to resume recording.
To record on the other side of the cassette
Turn the cassette over and press [ 
].
If the CD finishes before the cassette
Recording continues. Press [ 
/ 
STOP/EJECT ] to stop it.
If the cassette finishes before the CD
The CD continues playing. Press [ 
] to stop it.
Erase protection | Side A | |
Use a screwdriver or similar object | ||
| ||
to break out the tab. |
| |
| Tab for side B |
To
Cover the hole with adhesive tape.
Tab for side A
Adhesive tape
Press [ |
| / |
| STOP/EJECT ] to | Exposed tape facing | ||
1 open the deck and load a cassette. | upward |
|
| ||||
| |||||||
Close deck by hand. |
|
|
| ||||
Side to be recorded 
facing you
2 Select the source to be recorded.
When recording radio broadcasts
Tune in the station. (Perform steps
When recording CDs
Insert the CD to be recorded.
(Perform steps 1 and 2 of “Normal play” on page 7.) Press [CD 
/ 
] and then [ 
] to switch to CD mode.
If you want to record programmed tracks, program desired tracks before proceeding to step 3.
3 | Press [ | ] to start recording. | ]. |
| [ PLAY ] is also depressed with [ | ||
Recording starts (one side only).
The CD also starts playing if in CD mode.
To erase a tape
1.Press [TAPE/OFF].
2.Insert the cassette with the side to be erased facing towards you and the exposed tape facing up.
3.Press [ 
].
[ 
PLAY ] is depressed at the same time.
Note
•Noise may be recorded if this unit is near a TV. Keep the units at least 1.5 meters apart.
•Changes to volume and sound quality do not affect recording.
•To prevent interruptions to recording, make sure there is constant AC power supply to the unit or replace the batteries.
•While recording you cannot perform the following operations.
-Switching play of the source (CD, Radio, Tape)
-Switching the radio AM/FM frequency
-CD skipping, searching
Setting the time
1
2 · 4
3
This is a
1 Press [TUNER/BAND 
/ 
], [
PLAY] to turn the unit on.
Remote control only
2 Press [CLOCK/TIMER ADJ] once.
3 | Within 10 seconds | ||
| Press | ] or [ | / +] to set the |
time.
Press and hold to change the time faster.
Remote control only
4 Press [CLOCK/TIMER ADJ].
To switch to clock display
Press [DISPLAY].
Clock display ← → Current display
Displaying the clock temporarily
Press [CLOCK/TIMER ADJ].
The clock is shown for about 10 seconds.
Note
The clock is accurate to within ± 60 seconds a month. Readjust if necessary.
9
RQTT0585
