Recording operations

18

RQT5142

Automatic CD recording

You can record the whole CD (AUTO) or a selected track(1- REC). If a track is interrupted at the end of the side facing up, it is recorded again on the side facing down.

AUTO

Recording begins from the side facing up and the reverse

mode is set to “ ”.

Preparation: Insert a CD ( page 9)

Press [ TAPE/CD] to switch to CD mode.

Press [CD REC MODE] so “ AUTO” is dis- played.

Each time the button is pressed

AUTO 1-REC OFF

The display shows the length of tape needed.

“C-- -- -- --” indicates the tape needed exceeds 100 minutes. You can still record, but some tracks may not be recorded if the tape isn’t long enough.

Press [ DECK 2] to open the deck and load a cassette.

Close deck by hand.

Press [ ] to start recording.

The unit rewinds the tape, records 10 seconds of si- lence, and then starts recording.

To stop recording

Press [ TAPE/CD]. The CD also stops.

To record selected tracks

Program tracks ( steps and on page 11).

Do steps to .

You cannot use AUTO with repeat or random play ( page 10).

1-REC

Preparation:

Insert a CD ( page 9) and a cassette.

Wind the tape to where you want to start recording.

Press [ TAPE/CD] to switch to CD mode.

Press [CD REC MODE] so “ 1-REC ” is dis- played.

Turn [ TIME/PRE.TUNE/CD] to select the track you want to record.

Press [ ] to start recording.

CD play and recording start at the same time.

To stop recording

Press [ TAPE/CD]. The CD also stops.

To continue recording from another CD

Press [ CD OPEN/CLOSE] and insert the other CD. Do steps and .

To record a track while it is being played

Press [CD REC MODE] so “1-REC ” is displayed.

Press [ ].

Recording starts from the beginning of the track and stops when the track finishes.

Page 18
Image 18
Panasonic RX-ED50 manual Automatic CD recording, To continue recording from another CD