19
RQT9756
Others
As a factory preset, this unit will always turn off
automatically if there is no sound output and no
operation for approx.30 minutes.
To cancel this function
1Press [SETUP] repeatedly to select “AUTO OFF”.
2Press [3,4] to select “OFF” and then press [OK].
≥To turn automatic standby on, select “ON” in step 2.
The brightness of this unit’s display can be changed.
1Press [SETUP] repeatedly to select “DIMMER”.
2Press [3,4] to select “ON” and then press [OK].
≥To cancel the dimmer, select “OFF” in step 2.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1Press [CD] to select “CD”.
2While pressing and holding [SELECTOR] on the
unit, press and hold [CD/RADIO] on the remote
control until the unit's display shows “REMOTE2”.
3Press and hold [OK] and [CD/RADIO] on the
remote control for at least 4 seconds.
≥To change the mode back to “REMOTE1”, repeat the steps
above but replace the button pressed on the remote control
from [CD/RADIO] to [ ].
Occasionally, Panasonic may release updated
software for this unit that may add or improve the way
a feature operates. These updates are available free of
charge.
Preparation
≥Turn the unit on.
≥Connect this unit to the wireless netw ork. (l7)
– Make sure that the wireless network is connected
to the Internet.
– If “D.CONNECT” is set to “ON”, change the setting
to “OFF” and connect this unit to a wireless
network that is connected to the Internet.
1Press [SETUP] repeatedly to select
“SW UPDATE” and then press [OK].
2Press [3,4] to select “UPDATE? Y” and then
press [OK] to start the update.
3When the update has finished successfully,
“SUCCESS” is displayed.
4Disconnect the AC mains lead and reconnect it
after 3 minutes.
≥Downloading will require several minutes. It may take
longer or may not work properly depending on the
connection environment.
≥If you do not want to update the unit, select “UPDATE?N”
and then press [OK] in step 2.
≥If there are no updates, “NONEED” is displayed after step 2.
∫Checking the software version
1 Press [SETUP] repeatedly to select “SWVER.” and th en
press [OK].
{. The version of the installed software is displayed.
2 Press [OK] to exit.
Automatic standby
≥
This setting cannot be selected when “DAB/DAB+” (
[SC-HC58DB]
)
or “FM” is the source.
Display brightness
Changing the unit and remote
control code
Software update
DO NOT DISCONNECT the AC mains lead while
one of the following messages is displayed.
– “LINKING”, “UPDATING” or “%”
(“ ” stands for a number.)
≥During the update process, no other operations can be
performed.
SC-HC58DBEB_DBGN_GS~RQT9756-B.book 19 ページ ２０１３年１月２９日 火曜日 午前１０時１２分