Panasonic SC-PM38 specifications Preparing the remote control, Demo function, Simple setup

Simple setup (continued)

Optional antenna connections
FM outdoor antenna	AM outdoor antenna
FM outdoor antenna (not included)	AM outdoor antenna
	(not included)

5 to 12 m	AM loop antenna
	(included)

75 Ω coaxial cable (not included)

•Never use an outdoor antenna during a lightning storm.

•You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.

•Disconnect the FM indoor antenna if an FM outdoor antenna is installed.

•Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m of vinyl-covered wire horizontally along a window or other convenient location.

ENGLISH

Preparing the remote control

Batteries

•Use a manganese dry battery or an alkali dry battery.

•Insert so the poles (+ and –) match those in the remote control.

•Remove if the remote control is not going to be used for a long period of time.

•Store in a cool, dark place.

•Do not heat or expose to flame.

•Do not leave the batteries in an automobile exposed to direct sunlight for a long period of time with doors and windows closed.

•Mishandling of batteries in the remote control can cause electrolyte leakage, which may cause a fire.

Use

Aim at the remote control sensor, avoiding obstacles, at a maximum range of 7 m directly in front of the unit. Refer to page 6 for remote control signal sensor position.

R6/LR6, AA

Place this side in before the other side

Do not:

•mix old and new batteries;

•use different types of batteries at the same time;

•take apart or short-circuit;

•attempt to recharge alkaline or manganese batteries;

•use batteries if their covering has been peeled off.

CAUTION

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

DEMO function

				DEMO
				VOLUME
iPod	USB	FM/AM	CD
/	/		/
			_	+
				OPEN/CLOSE

When the unit is first plugged in, a demonstration of its

functions may be shown on the display.

[g, –DEMO]If the demo setting is off, you can show a demonstration by selecting “DEMO ON”.

Press and hold [g, –DEMO].

The display changes each time the button is held down.

DEMO OFF DEMO ON

While in standby mode, select “DEMO OFF” to reduce power consumption.

RQTX0215

5