Listening to the radio

Presetting stations automatically

Up to 30 stations can be set.

1 Press [RADIO]4 to select “FM”.
2 Press [MENU]C.

Each time you press the button:

LOWEST (factory preset):

To begin auto preset with the lowest frequency.

CURRENT:

To begin auto preset with the current frequency.§

§To change the frequency, refer to “Manual tuning” (B right).

3 Press and hold [OK]8.

Release the button when “FM AUTO” is displayed.

The tuner starts to preset all the stations it can receive into the channels in ascending order.

≥“SET OK” is displayed when the stations are set, and the radio tunes to the last preset station.

≥“ERROR” is displayed when auto presetting is unsuccessful. Preset the stations manually (B right).

Listening/confirming the preset channels

1 Press [RADIO]4 to select “FM”.

2 Press the numbered buttons to select a channel.

≥To select a 2-digit number e.g. 12: [S10]2 B [1] B [2]

Alternatively, press [X, W]@.

≥The FM setting is also shown on the TV display.

If noise is excessive

Press and hold [PLAY MODE]9 to display “MONO”.

To cancel the mode, press and hold the button again until “AUTO ST” is displayed.

≥The mode is also cancelled when you change the frequency.

Manual tuning

1 Press [RADIO]4 to select “FM”.

2 Press [SEARCH6, SEARCH5]? to select the frequency.

≥To start auto tuning, press and hold [SEARCH6,

SEARCH5]? until the frequency starts scrolling. Tuning stops when a station is found.

Presetting stations manually

Up to 30 stations can be set.

1While listening to the radio broadcast

Press [OK]8.

2While the frequency is flashing on the display

Press the numbered buttons to select a channel.

≥To select a 2-digit number e.g. 12: [S10]2 B [1] B [2]

Alternatively, press [X, W]@, and then press [OK]8.

A station previously stored is overwritten when another station is stored in the same channel preset.

FM frequency step

The step is factory-set to 0.2 MHz, but you can change it to receive broadcasts allocated in 0.1 MHz steps. You may need to change this setting if the tuner seems to skip over the correct frequency for stations in your area.

1Press [RADIO]4 to select “FM”.

2Press and hold [< OPEN/CLOSE]2 on the main unit.

After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed.

e.g. 87.9 (Factory preset) ,# 87.5

To return to the original step, repeat steps 1 and 2.

After changing the setting, previously preset frequencies will be cleared. Preset them again.

Quick Start Guide Getting Started

RQTX1326

9