Connection
Speaker setting
When the speakers are detected, the Wireless Link display lights up on the main unit’s |
| Display | ||
|
|
|
| |
|
|
|
| |
display. | W |
|
| Wireless Link |
(Blinks during detecting operation.) |
|
| ||
|
|
| display | |
|
|
|
|
While the wireless speakers operate normally, the Wireless Link display lights, but when radio waves are interrupted (When speakers are in standby condition, etc.), it blinks.
•When you turn the main unit off with the speakers on, the speakers automatically enter standby (Wireless link standby). The color of [WIRELESS LINK] indicator turns to red.
•To reduce more of the power consumption of speakers in standby, turn the speakers off. The speakers enter standby (In standby
condition).
<Power consumption of speakers in standby> Wireless link standby: approx. 0.8 W (for 1 speaker) In standby condition: approx. 0.1 W (for 1 speaker)
Checking the speaker setting
1. | Turn the main unit on. |
|
|
2. | Press [TEST] on the remote | • To adjust the speaker volume, press [VOL | +, |
| control to output the test signal. |
|
|
Press
3. Make sure that the display of main unit matches speaker locations.
The test signal is output from one speaker at a time for about 2 seconds in the order shown below. “TEST L ” → “TEST R ” → “TEST RS ” ✽ → “TEST LS ” ✽
Speaker setting
Confirm the correct setting locations in the following chart.
Display | Speaker outputting the test signal |
|
|
TEST L | Front left |
|
|
TEST R | Front right |
|
|
TEST RS ✽ | Surround right (right back) |
TEST LS ✽ | Surround left (left back) |
✽This is not displayed
when using the front speakers only.
Note
If the speakers are not properly set, do either of the following.
•Move the speakers according to the unit’s display.
•Perform steps 3 and 4 of “Setting the speakers” (➜ page 13). When using only front speakers, perform steps 4 and 5 of “Setting front speakers only” (➜ page 15).
4.Press [TEST] on the remote control to stop the test signal.
If the speaker is repaired or replaced
Perform the above “Checking the speaker setting” to confirm that the speaker properly operates.
Do the following operations if the sound is not produced normally.
1.Press and hold [INPUT SELECTOR] on the main unit about 3 seconds until “4CH SEARCH ” is displayed.
2.Perform steps 2 to 4 of “Setting the speakers” (➜ page 13).
14
RQT9471