12
“ERROR”
• An incorrect operation was done. Read the instructions
and try again.
“NOT MP3/ERROR”
• An unsupported MP3 format. The system will skip that
track and play the next one.
“VBR–”
• The system cannot show the remaining play time for
variable bit rate (V B R ) tracks .
“NORMAL”
• The “INPUT LEVEL” of AUX source automatica lly
changes from “HIGH” to “NORMAL” when the system
detects distorted music sounds.
“NODEVICE”
• The USB device is not connected. Examine the
connection.

Memory reset (initialization)

Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory conte nts.
1
Disconnect the AC power supply cord.
2
While you press and hold [1] on the main unit,
connect the AC power supply cord again.
“– – – – – – – –” is shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.

Remote control code

When other Panasonic equipment responds to the remote
control of this system, change the remote control code for
this system.
Preparation
Press [RADIO, EXT-IN] (main unit: [RADIO/EXT-IN]) to
select “AUX”.
To set the code to “REMOTE 2”
1
Press and hold [RADIO/EXT-IN] on the main unit
and [2] on the remote control until “REMOTE 2” is
shown.
2
Press and hold [OK] and [2] for a minimum of
4 seconds.
To set the code to “REMOTE 1”
1
Press and hold [RADIO/EXT-IN] on the main unit
and [1] on the remote control until “REMOTE 1” is
shown.
2
Press and hold [OK] and [1] for a minimum of
4 seconds.

Maintenance

To clean this system, wipe with a soft, dry cloth
• Never use alcohol, paint thinner or benzine to clean this
system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
AKX14P.En.book Page 12 Tuesday, January 31, 2012 2:46 PM