Listening
Note:
The following can occur if there is a problem with the card:
•“Now Busy” or “EMERGENCY STOP” appear frequently (see page 11)
•“Please Wait” appears for 20 seconds or longer
•No sound continues for 20 seconds or
longer after pressing [ 
] to play
You can remedy the problem by formatting the card with
Before formatting the card, check in any data on the card to your computer. See the operating instructions for
1 | Set to NORMAL. | |
HOLD | ||
| ||
| MODE NORMAL |
2 |
| Connect the stereo |
| earphones. | |
Plug in |
|
|
firmly. |
|
|
Stereo earphones |
|
|
3 | Bottom Insert an SD Memory | |
view | Card with tracks | |
| ||
|
| recorded (checked out). |
|
| Open the cover. |
Corner cut |
| |
|
| Insert the card so the label is facing up |
|
| and the end with the corner cut off is |
Label |
| facing in. |
|
| Push on the center of the card so it locks |
|
| into place and close the cover. |
4 |
| Press. The unit comes on and |
| starts play. | |
|
| Immediately |
|
| after pressing |
|
| Operation display |
|
| After about |
|
| two seconds |
5 | Adjust the volume. |
Reduce Increase Press and hold to adjust continuously. | |
| Volume meter |
Volume (0 to 25)
To stop play and turn
the unit off
Press.
The unit turns off about ten seconds later.
Resume
When you next press [ 
], play resumes from where you stopped it. Play starts from track 1 if you replace the card or battery.
To remove
the SD Memory Card
Bottom
view
After stopping play, open the card cover (step 3, 
), and push on the center of the card to unlock it.
Hold function
This function stops the unit from responding when a button is pressed.
HOLD 
HOLD
MODE 
NORMAL
It prevents the following:
•The unit turning on unexpectedly, causing the battery to go dead.
•Play being interrupted when a button is accidentally pressed.
4 | 5 |
