SET UP for Input Signals
Select SIGNAL from the “SET UP” menu during RGB or PC input signal mode.
Press to select each item.
Press to adjust.
The following operation methods are the same for both the SIGNAL [RGB] and SIGNAL [PC].
SYNC
Setting RGB sync signal
Confirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT).
H&V: The H and V sync signals are input from the HD/VD connector.
ON G: Uses a synchronized signal on the Video G signal, which is input from the G connector.
ON VIDEO: Compatible with the scart plug (Europe)
The composite video signal input from the VIDEO input terminal is used by dividing the sync signals.
SIGNAL |
| [ RGB ] |
SYNC |
| H & V |
| NARROW | |
CLAMP POSITION |
|
|
SIGNAL |
| [ COMPONENT ] |
CLAMP POSITION |
|
|
SIGNAL |
| [ PC ] |
SYNC |
| H & V |
| NARROW | |
CLAMP POSITION | 31 5 | kH |
H FREQ |
SYNC | H & V |
SYNC | ON G |
SYNC | ON VIDEO |
Setting PC sync signal
Confirm that the input is set to PC INPUT (this setting is valid only for PC INPUT). H&V: The H and V sync signals are input from the HD/VD connector.
ON G: Uses a synchronized signal on the Video G signal, which is input from the G connector.
PULL IN RANGE
Sets the width for different frequencies.
(This setting is the same for both SIGNAL [RGB] and SIGNAL [PC].)
CLAMP POSITION
Adjusts the clamp position.
The following operation methods are the same for “SIGNAL” menu during COMPONENT, RGB and PC input signal mode.
Normally, these adjustments are set to appropriate levels, and therefore, do not need to be altered.
PULL IN RANGE | NARROW |
PULL IN RANGE | WIDE |
CLAMP POSITION
H-FREQ (kHz)/V-FREQ (Hz)
Displays the H (Horizontal)/V (Vertical) frequencies.
This display is valid only for RGB input and PC input. Display range:
Horizontal 15.5 - 110 kHz Vertical 48 - 120 Hz
31.5
60.0
kHz Hz
34
