11
Connection
12
DEDICATED RECEIVER IN SERVICE USE
1
21
2
SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
– Cable fixing bands
Secure any excess cables with bands as required.
Note:
Please turn off the power of the Plasma Display unit and Digital Media Receiver when connecting or removing Display - Receiver cable.
Display connection
When connecting the speakers, be sure to use only the optional accessory speakers.
For details on installation and connection of the speaker, refer to the Speaker’s Installation Manual. (Supplied)
Speakers
Pass the attached cable
fixing band through the
clip as shown in the
figure.
To secure cables connected to Terminals, wrap the cable fixing band
around them then pass the pointed end through the locking block, as
shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the supplied
fixing band.
AC cord connection
(see page 19)
To tighten: To loosen:
Pull Pull
Push the catch
3. Slide up the clamper and fix
the AC cord plug securely.
2. Insert the AC cord and
close the clamper
securely.
1. Open the clamper.
Clamper AC cord
Note: The power plug in the illustration may not be the type fitted to your set.
To loosen the
clamper:
– AC cord fixing
To DEDICATED DISPLAY OUT
connector on Digital Media Receiver These terminals are not in use.