ECO MODE SETTINGS

Select “ECO MODE SETTINGS” in “SETUP” menu and pressbutton.

ECO MODE SETTINGS

 

 

 

 

 

ECO MODE

 

CUSTOM

 

POWER SAVE

OFF

 

STANDBY SAVE

ON

 

PC POWER MANAGEMENT

OFF

 

DVI-D POWER MANAGEMENT

OFF

 

NO SIGNAL POWER OFF

DISABLE

 

 

 

 

1 select

2 adjust

ECO MODE

CUSTOM: The menu of power consumption reduction is individually set.

ON: The following fixed values are set to the menu of power consumption reduction. Individual setting is not available.

POWER SAVE: SENSOR

DVI-D POWER MANAGEMENT: ON

STANDBY SAVE: ON

NO SIGNAL POWER OFF: ENABLE

PC POWER MANAGEMENT: ON

 

Using Remote Control

When is pressed, the “ECO MODE” setting changes.

 

 

 

 

 

ECO MODE

ON

 

 

 

 

 

Custom settings

The menu of the power consumption reduction is individually set. This setting is enabled when “ECO MODE” is set to “CUSTOM”.

POWER SAVE

When this function is turned ON, luminous level of the Plasma Display is suppressed, so power consumption is reduced. SENSOR: The luminous level of the Plasma Display is automatically adjusted according to the viewing environment.

STANDBY SAVE

When this function is turned ON, power consumption of the microcomputer is reduced during power supply standby (see page 16, 19, 20), so standby power of the set is reduced.

PC POWER MANAGEMENT

When this function is set to ON, it operates under the following conditions to turn the power on or off automatically. When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal input:

→Power is turned off (standby); the power indicator lights up orange. When pictures (HD/VD sync signals) are subsequently detected:

→Power is turned on; the power indicator lights up green.

Notes:

•This function operates only during PC signal input.

•This function is effective when “SYNC” is set to “AUTO”, “COMPONENT / RGB-IN SELECT” is set to “RGB” and during normal viewing.

DVI-D POWER MANAGEMENT

When this function is set to ON, it operates under the following conditions to turn the power on or off automatically. When no pictures (sync signal) are detected for 30 or so seconds during DVI signal input:

→Power is turned off (standby); the power indicator lights up orange. When pictures (sync signal) are subsequently detected:

→Power is turned on; the power indicator lights up green.

Notes:

•This function operates only during DVI signal input.

•This function is invalid during input from DVI-D Terminal Board (TY-FB11DD).

•Depending on the type of terminal board equipped, this function may be invalid.

NO SIGNAL POWER OFF

Equipment power supply is turned OFF when there is no signal.

When this is set to “ENABLE”, the power supply of the unit goes Off 10 minutes after the input signals stop.

43