SETUP for Input Signals
• SYNC
This function operates only during input from PC IN terminal.
Setting RGB sync signal
Confirm that the input is set to RGB input (this setting is valid only for RGB input signal).
AUTO:The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.
ON G: Uses a synchronized signal on the Video G signal, which is input from the G connector.
Setting Component sync signal
Confirm that the input is set to Component input (this setting is valid only for Component input signal).
AUTO:The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.
ON Y: Uses a synchronized signal on the Video Y signal, which is input from the Y connector.
Note:
Signals input to COMPONENT/RGB IN terminals correspond to SYNC ON G or SYNC ON Y.
• SDI THROUGH
Set the active through function of the Dual Link
OFF 
ON
ON: Enables active through.
OFF: Disables active through.
Note:
Settings can only be performed for this menu when a slot mounted with a Dual Link
• FRAME CREATION
Automatically compensates the picture frame rate and removes juddering movements to make the images smooth.
OFF 
MID 
MAX
Note:
Depending on the contents, images may be noisy. To prevent the noise, change the setting.
• 3D REFRESH RATE
Reduces juddering or flicker of image due to lighting interference during 3D viewing.
100Hz 
120Hz Note:
This setting is disabled when “FRAME CREATION” is set to “OFF”.
• HDMI RANGE
Switches the dynamic range according to the input signal from HDMI terminal.
VIDEO(16-235) 
FULL(0-255) 
AUTO
AUTO: Switches the dynamic range automatically between
Note:
This function can be set only for HDMI signal input.
53