lO~VQid···Malfunctions

•About the Handlingofthe3DConversionLens
•Sand or dust will cause malfunctions
in
the 3D
Conversion Lens. Be careful not to allow sand or
dust to get inside the 3D Conversion Lens when
using at the beach or similar.
•The 3D Conversion Lens
is
not waterproof. Wipe
with adry cloth
if
any water gets
on
it.
Contact the retailer or the service center when
it
does not operate properly.
•Image may be affected when the surface of the
protective glass is contaminated
by
water, oil,
fingerprints, etc. Wipe the surface of the protective
glass gently with adry soft cloth before and after the
recording.
•Remove the 3D Conversion Lens from the video
camera and place it
in
the lens storage bag when
carrying.
English
•About Condensation (When the 3DConversion LensisFogged Up)
•Condensation occurs when there
is
adifference
in
the
temperature or humidity as
in
the following cases. Be
careful since it may cause contamination, mold,
or
malfunction
of
the
3D
Conversion Lens.
-When it
is
carried indoors from acold outdoor
environment
-When carried out from acool, air-conditioned car,
etc.
-When cool wind from
an
air conditioner is directly
blown onto the lens
-
In
an
area with high humidity
•
To
prevent condensation, place
in
aplastic bag and
allow it to warm up to the ambient temperature. If any
condensation occurs, leave it as it
is
for
approximately 1hour. Condensation will disappear
on
its own once it is warmed up to the ambient
temperature.
3
(ENG)VQT3A68