Panasonic WS-AT300 On wall or ceiling, Secure the Speaker, Mounting on a stand

-5-

You can install the speaker on a wall or ceiling with a

mounting bracket (not supplied).

qPlace the bracket on the enclosure.

wScrew the eye bolts into the screw holes of the

enclosure by hand.

eFix the speaker to a wall or ceiling.

rTake safety protections mentioned in “Secure the

speaker.”

Note: Installers should seek advice on the building

structure and load capacity, if unknown, from

an architect or a structural engineer.

Use safety wires (not supplied) when hanging the

speaker from a wall or ceiling. This is not a major

means of support but just a safety relief.

qTighten the eye bolts with washers and bolt nuts

(not supplied) into the screw holes of the enclosure

by hand.

wSet the direction of the eye bolts to be in the best

position for binding safety wires.

eFasten the bolt nuts with wrench.

rBind one end of safety wires to the eye bolts.

tSecure the other end of safety wires to the

supporting structure of the building.

1. You can mount the speaker on a speaker stand by

using the stand hole in the enclosure bottom.

2. The stand should have a supporting pipe of ø1.5

inches.

3. Take safety protections by placing it in a safety

location, for exemple.

INSTALLING THE SPEAKER

Eye Bolt

Washer

Set direction

Bolt nut

Tighten with wrench

Hand

tighten

Hand

tighten

Insert

Mounting

bracket

Stand hole

(Bottom side)