Panasonic WV-CF254 manual Shutter Speed Setting Shutter, Gain Control Setting AGC ON/OFF

4.Repeat step 1 to 3 to mask the desired areas. To cancel masking, move the cursor to that

area and press (S).

Turns to white

Blinking

5.After masking is completed, press (S) for 2 seconds or longer. The ALC CONT menu appears.

6.If you want to change the video output level (picture contrast), move the “I” cursor to LEVEL and adjust the level.

7.Move the cursor to RET and press (S) to return to the CAM SETUP menu. (To return to the camera picture, move the cursor to END and press the set button.)

3.Shutter Speed Setting (SHUTTER)

Note: When ON is selected for SUPER-D on the ALC CONT menu, this item is not available.

To select electronic shutter speed, select OFF for SUPER-D in the menu.

You can select an electronic shutter speed of 1/60 (OFF), 1/100, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000, or 1/10 000 seconds.

** CAM SET UP **

CAMERA ID		OFF	↵
ALC/ELC		ALC	↵
SHUTTER		---
AGC		ON
SYNC		INT
WHITE BAL		ATW	↵
END	SET UP ENABLE

Move the cursor to the SHUTTER parameter and select the electronic shutter speed.

The preset values for SHUTTER (electronic shutter

speed) change by pressing (L) or (R) as follows:

OFF (1/60) 1/100 1/250 1/500

1/10000 1/4000 1/2000 1/1000

4. Gain Control Setting (AGC ON/OFF)

You can set the gain (brightness level portion of an image) to automatic level adjustment (ON) or fixed level (OFF).

** CAM SET UP **

CAMERA ID		OFF	↵
ALC/ELC		ALC	↵
SHUTTER		---
AGC		ON
SYNC		INT
WHITE BAL		ATW	↵
END	SET UP ENABLE

Move the cursor to the AGC parameter and select automatic level adjustment (ON) or fixed level (OFF).

5. Synchronization Setting (SYNC)

You can select internal sync mode (INT) or line-lock mode (LL). The VD2 signal (multiplexed vertical drive signal) with the composite video output signal from external equipment such as a Matrix Switcher is also acceptable.

Whenever the VD2 signal is supplied to this cam- era, the camera automatically switches to the VD2 sync mode.

1.Move the cursor to the SYNC parameter and select line-lock (LL) or internal (INT).

2.Press (S).

If LL is selected, the SYNC menu appears. (If INT is selected, the synchronization mode is automatically set to internal sync pulse, and the menu is not displayed.)

** CAM SET UP **

CAMERA ID		OFF	↵
ALC/ELC		ALC	↵
SHUTTER		---
AGC		ON
SYNC		INT
WHITE BAL		ATW	↵
END	SET UP ENABLE

Important Notices:

1.The priority for the sync modes is as follows.

1.Multiplexed Vertical Drive (VD2) (Highest priority)

2.Line-lock (LL)

3.Internal Sync (INT) (Lowest priority)

2.The line-lock mode has its own menu for line- lock vertical phase adjustment. If the camera installation is relocated, check the vertical phase adjustment again since the AC line phase may be different.

-17-