Panduit PN433 manual FMTPRR6 - Replacing FMTPFCT and FMTPMFCT Cleaning Reel

INSTALLATION INSTRUCTIONS PN433

FMTPRR6 - Replacing FMTPFCT and FMTPMFCT Cleaning Reel

1.The cleaning reel should only be replaced in a clean and dust free environment. A contaminated cleaning reel may cause damage to fibers.

2. Use a coin or	3. Open and remove
screwdriver to	the cover using the
loosen the screw	finger grip on the
located on the front	side of the tool.
of the FMTPFCT or
FMTPMFCT Fiber
Cleaning Tools.

4.	Remove the	5.	Place the empty
	cleaning reel and		winding reel next to
	winding reel by		the new cleaning
	lifting them straight		reel as shown.
	out of the tool.		Detach the
	Remove the		adhesive tape from
	cleaning tape from		the cleaning reel
	the winding reel.		and attach to the
	Do not discard the		winding reel.
	blue winding reel.
6.	Place the winding	7.	Hook the cover on
	reel and the		the tool body and
	cleaning reel into		swing the cover
	the tool and route		closed. Tighten the
	the cleaning tape as		screw.
	shown on the
	diagram located on
	the tool cover.

Winding Reel Cleaning Reel

Hooks

8. Depress the green lever a few times and verify that the cleaning tape is advancing properly.

*MTP is a registered trademark of US Conec Ltd.

For Instructions in Local Languages		E-mail:
		cs@panduit.com
and Technical Support:
		Fax:
www.panduit.com/resources/install_maintain.asp	www.panduit.com
		(708) 444-6993
	Page 4 of 4