ParaBody 824 manual Parts List, Refer to While Reading Assembly Instructions

PARTS LIST

KEY	PART #	DESCRIPTION	QTY
1	6416402	LEG EXTENSION	1
2	6416302	LEG EXTENSION NECK	1
3	6125101	ROLLER PAD SHAFT	2
4	6406501	U-PIN	1
5	6194601	ROLLER PAD	6
6	3102910	1/2 X 3” BOLT	1

KEY	PART #	DESCRIPTION	QTY
7	3102502	1/2” FLAT WASHER	2
8	3102804	1/2” LOW HEIGHT LOCK NUT	1
9	6020601	1/2” FLANGE BEARING	2
10	3105401	3/4” STAR LOCK	6
11	6236701	1-3/4” SQ. END CAP	4
12	3104301	3/4” SQ. RUBBER BUMPER	1

		6
	7
	8		9
			1	10
				5
				3
	2
				11
	4	12
PIN STOP				U-PIN
FIGURE 1		UPRIGHT TUBE,		DETAIL A
		BENCH FRAME

REFER TO FIGURE 1 WHILE READING ASSEMBLY INSTRUCTIONS

*Insert one 1-3/4” END CAP (11) into the top of the LET EXTENSION NECK (2).

*Slide two ROLLER PADS (5) over each end of the shaft on the LEG EXTENSION NECK (2) and hold in place using two STARLOCK COLLARS (10)

*Insert three 1-3/4” END CAP (11) into the ends of the LEG EXTENSION (1)

*Insert two 1/2” FLANGE BEARING (9) into the bushing on the LEG EXTENSION (1)

*Assemble the LEG EXTENSION NECK (2) to the LEG EXTENSION (1) using one 1/2 X 3” BOLT (6),

two 1/2” FLAT WASHERS (7) and one 1/2” LOCK NUT (8). (TIGHTEN THE CONNECTION ENOUGH

TO REMOVE THE PLAY, YET ALLOWING THE LEG EXTENSION TO ROTATE FREELY)

*Assemble four ROLLER PAD (5) to the LET EXTENSION (1) using two ROLLER PAD SHAFT (3) and four STARLOCK COLLAR (10)

*Attach one 3/4” RUBBER BUMPER (12) to the LEG EXTENSION (1) approximately as shown

4