Desa TSTPA-A, TSTEA-A High altitude installation, Parts list for Desa venting kits and components

Venting Installation

Instructions

45° Starter Elbow

Continued

12" Extension

Vertical Venting

V = 40' max.

45° Starter

Elbow

Note: Install restrictor into inner collar of fireplace as shown.

Figure 32 - Vertical Rigid Venting

Configuration With No Horizontal Run

High altitude installation

Your DESA direct-vent fireplace has been tested and approved for elevations from 0-2,000 feet (USA) and elevations from 0-4,500 feet (Canada)

Fireplaces for High Altitude (models ending in -HA) are for installation above 4,000 feet only. These fireplaces are equipped with parts specific for higher altitudes. IMPORTANT: These fire- places can NOT be converted to propane/LP gas. When installing a non-high altitude fireplace at an elevation above 2,000 feet (USA), you may need to decrease the input rating by changing the existing burner orifice to a smaller size. Reduce input 4% for each 1,000 feet above sea level. Check with your local gas company for proper orifice size identification.

When installing this fireplace at an elevation above 4,500 feet (Canada), check with local authorities.

IMPORTANT: For horizontal installations above 2,000 feet, it is recommened that a 12" extension pipe be added before starter elbow (see Figure 33).

Figure 33 - Recommended 12" Extension

for High Altitude Installation

parts list for DESA venting kits and components

DESA (5"/8") Pipe & Vent Kits

Number Description

VKR-58 Roof Vent Kit, Galvanized

(Includes: 45° Elbow, 7"-12"

Adjustable Pipe, Flue Restrictor,

Vertical High Wind Termination,

2' Pipe, 4' Pipe, Wall Firestop,

Storm Collar, Roof Flashing

[0/12 - 6/12], 26 Screws)

VKB-58 Basement Vent Kit, Galvanized

(Includes: 45° Elbow, 7"-12"

Adjustable Pipe, Wall Firestop,

Horizontal Square Termination,

4' Pipe, 90° Elbow, 20 Screws)

VKS-58 Snorkel Vent Kit, Galvanized

(Includes: 45° Elbow, 7"-12"

Adjustable Pipe, Wall Firestop,

36" Snorkel Termination, 4' Pipe,

1' Pipe, 90° Elbow, 26 Screws)

VKG-58 Ground Floor Vent Kit, Galvanized

(Includes: 45° Elbow, 7"-12"

Adjustable Pipe, Wall Firestop,

Horizontal Square Termination,

16 Screws)

P58-48 48" Section Double Wall Pipe,

Galvanized

P58-36 36" Section Double Wall Pipe,

Galvanized

P58-24 24" Section Double Wall Pipe,

Galvanized

P58-12 12" Section Double Wall Pipe,

Galvanized

P58-6 6" Section Double Wall Pipe,

Galvanized

56131-F www.desatech.com 19