Desa TSTA-A(-HA), (V)DVF36, TSTPA-A, TSTEA-A, TSTPEA-A, TPNPEA-A Open Close, Left Back Front Right

Installation

Continued

4.Figure 47 shows the log set. Logs “A” have the knot at the end of the log. Logs “B” have the knot at the middle of the log. Twigs “C” have the shape of a “Y”. Twigs “D” have the shape of bent twigs. Twig “E” is a straight twig which is placed across the top of Logs “B”.

5.Figure 48 shows the top view of the burner and grate.

6.Place logs “A” as shown in Figure 49.

7.Place logs “B” as shown in Figure 50. Lift the end of log “A” that will be propped up and place log “B” under it. At the same time, the other side of log “B” is placed over the other log “A”. Repeat procedure for the other log “B”.

8.Take twigs “C” (shaped like a “Y”) and place them as shown in Figure 51.

9.Take twigs “D” (bent twig) and place them as shown in Figure 51.

10.Place twig “E” across the top of logs “B” a shown in Figure 51.

11.When finished installing the logs, close the glass door. Make certain safety door switch is fully depressed by door frame before securing four (4) spring loaded latches.

12.Replace the louvers in reverse order with the grilles pointing in the down position.

WARNING: Improper installa- tion, adjustment, alteration, ser- vice, or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information, consult a qualified installer, service agency, or gas supplier.

Open

Close

Figure 46 - Opening Door Latches

	B	C
D
A
E	A
C
	D
	B
Figure 47 - Log Set (9 Pieces)
	Left
Back		Front

Right

Figure 48 - Burner and Grate (Top View)

	Left
Back	Front

Right

Figure 49 - Installing Logs “A” (Top View)

		Left
Back	A		Front
	B	B
		A
	Right

Figure 50 - Installing Logs “B ” (Top View)

		Left
	D		C
Back		E	Front
C			D

Right

Figure 51 - Installing Twigs “C, D, E ”

(Top View)

56131-F www.desatech.com 25