Sirius Satellite Radio SIR-BB3 manual Battery Installation, Cabling Interconnections

1.Battery Installation

Your Boom Box can operate independently of AC power by installing 8 D-Cell batteries as follows:

NOTE: The batteries are bypassed automatically whenever the supplied AC Adapter is plugged into the DC 12V jack on the back panel.

2.Cabling Interconnections

You can begin to enjoy Sirius® Satellite Radio as soon as the Shuttle and Boom Box Kit installation are complete. Set up your Audiovox SIR-BB3 by following the interconnect diagram.

3.Installing the Shuttle in the SIR-BB3 Install the shuttle as follows:

BATTERY	COVER LATCHES
	BOTTOM OF
COMPARTMENT
	BOOM BOX
COVER

1.Press the EJECT button at the top of the SIR-BB3 to open the spring-loaded cover. Carefully line up the shuttle rear spine grooves with the Boom Box guide spines; lower the shuttle into the Boom Box.

1.	Turn the Boom Box upside down to access
	the battery compartment.
2.	Push the battery cover latches forward and flip
	up the battery compartment cover to the open
	position.
3.	Insert eight (8) D-Cell batteries observing

		SHUTTLE REAR
		SPINE
SHUTTLE		GROOVES
REAR VIEW
SHUTTLE	EJECTBUTTON	SIR-BB3 GUIDE
		SPINES
COMPARTMENT

battery polarity as shown; then close the cover.

POSITIVE	NEGATIVE
BATTERY
COMPARTMENT
(COVER REMOVED)	POSITIVE
NEGATIVE

AUDIO OX

PNP COVER

SAT

CONNECTOR

CONNECTOR GUIDEPIN

20-PIN

SYSTEM CONNECTOR

-6-

128-7266A

6 of 12