ParaBody 874104 manual MULTI-ANGLE Bench Assembly Instructions, Tools Required Ratchet

874104 MULTI-ANGLE BENCH ASSEMBLY INSTRUCTIONS

INSTRU

TI4E

ASSURE ITS PROPER FUNCTION.

IF YOU EXPERIENCE ANY

CONTACT YOUR DEALER OR

AT: !-80/t-328-9714

TOOLS REQUIRED: RATCHET,

RUBBER MALLET or HAMMER

Insert one (I) U-PIN through the POSTon the BENCHFRAME,as shown on drawing. Slide one (t) X I IN. ~ ~ ~,ING over the U-PIN. Attach one (1) PALNUTto the end of the U-PIN.

Insert two (2) 2 IN. SQ. ENDCAPSinto both eiads of the REARBASETUBEas shown on drawing.

SECURELYassemble the REAR BASE TUBE to the BENCHFRAMEas shown on drawing, using two

~ ,two 3/8 IN. LOCK NUTS.

_ } ~ ~ X 3 IN. BOLTS,Ibm" (4) :/8 IN. WASHERS,and (2)

Insert two (2) 2 IN. SQ. ENDCAPSinto both ends of the FRONTBASETUBEas shown on drawing.

SECURELYassemble the FRONT BASE TUBE to the BENCHFRAMEas shown on drawing, using two (2) 3:3 X 3 IN. BOLTS, ibm (4) 3/8 IN. WASHERS,and two (2) 3/8 IN. LOCK

Insert one { t) 2 IN. SQ. ENDCAPinto the end of the PADSUPPORTas shown on drawing.

Loosely assemble the PAD SUPPORTand two (2) HINGE TABS to the BUSHINGon the BENCH FRA~E using one (I) 1/2 X 8 IN. BOLT and one (1) 1/2 LOWHEIGHT LOCKNUT.(DO NOT

TIGHTEN THE BOLT. THE PAD SUPPORT MUST ROTATE FREELY.)

Attach eight (8) PARAGLIDESTRIPS to both etads of the SWIVELas shown in (DETAILA) using lk)llowing steps:

¯I-horouglaly clean all surli~ces where the PARAGLIDESTRIPSare to be attached.

¯Removepaper backing fi'om the PARAGLIDESTRIPSand firmly apply them to all slnown surfaces.