ParaBody PBF501 manual PBFS01 EXS00 Base ~IT Assembly Instructions Step #I

PBFS01 EXS00 BASE ~IT ASSEMBLY INSTRUCTIONS (STEP #I)

TIIE INSTRUCTIONS FOR STEP #I ARE TO BE USED WITH DRAWING SHEET #I OF 6. THE PARABODY EXS00 BASE UNIT M'L!ST BE ASSEMBLED ON A FLAT LEVF, L SURFACE TO ASSURE ITS PROPER FUNCTION.

PARABODY INC. STRONGLY RECOMMENDS THAT TI-IIS PRODUCT BE ASSEMBLED BY TWO PERSONS TO AVOID POSSIBLE INJURY

*** IMPORTANT***

KEEP ALL LOOSE FRAME,

CONNECTIONS

LO,OSE UNTIL INSTRUCTED IN TI-~ ASSEMBLY STEP SEQUENCES TO

" -SECURELYTIGHTEN-

I	J___ I, ,	, I	.	- ~-.1....	~I	, .='
						~

Insert four (4) 2 IN. SQ. ENDCAPSinto the ends of the WEIGHTSTACKSUPPORTBASE.Also fnsert one (I) 1-112 x 2-1/2 ENDCAPinto the SWIVELPULLEYMOLrNTEXTENSIONon the

VVEIGI-ITSTACK SUPPORT BASE.

LOOSELYassembleone(I) 318 DIA.x I IN. LG. BUSI-IINGPULLEYintothe SWIVELPULLEY MOUNTusingone(I)3/8x 2 BOLT,one(])3/8LOCI(WASHER,andone(I) 318NUT(SEE "A").Inserttwo(2)112 x 3/4 LG.FLANGEBEARINGSintotheSWIVELPULLEYiViOUNTfrom bottomandtop.

Assemblethe SWIVEL PULLEYMOUNT to the WEIGHTSTACK SUPPORTBASE using one (I) I/2x 4-I/9_BOLT,one(I).I/°-WASHER,andone(l)I/2LOWHEIGHTLOCKNUT(SEEDETAIL "A").TightenconnectionsothatitswivelssmoothlyandfreelyPlace.theWEIGHTS'rACK SIIPPORTBASEfiaton thefloor.

Insertfour(4)2 IN.SQ.ENDCAPSintotheendsoftheTGPBOOMSECTIONCm'efully.placethe TOPBOOMSECTIONon itssideon thefloor.

:5. Carefully place the NIALNBACKSUPPORTon its side on the floor and loosely assemble the MAIN BACKSUPPORTto the TOP BOOMSECTION,using two (2) 1/2 x 7. BOLTS,four (4) WASHERS,two (2) 1/2 LOCI( WASHERS,and two (2) 1/2