ParaBody PBF501 manual PBFb01 EXb00 Base Unit Assembly Instructions #

PBFb01 EXb00 BASE UNIT ASSEMBLY INSTRUCTIONS #!)

o

Insert one (1) 2 IN. SQ. ENDCAPinto the BASESEATSUPPORTand carefully place it on its side the floor.

, "~~,8X 1-

Loosely assemble the BASESEATSUPPORTto the MAINBACKSUPPORT,using two (2) 1/4 BOLTS,four (4) 378 WASHERS,two (2) 3/8 LOCKWASHERS,and two (2) 3/8

Insert a 2 IN. SQ. ENDCAPinto the opert end office EASETEESECTION.

Loosely assemble the BASETEE SECTIONto the MAINBACKSUPPORTASSE~CEBLY(from step

#7),at thefollowingtwocormect~onpoints:ENDCONNECTION~one- (I)I~ x 5 BC~LT,two(2)

WASHERS,one (I) 1/2 LOCKWASHER,and one (1) 1/2 NUT; and the INSIDE CONNECTION:

(I)I/2 x 7 BOLT,two (2) 1/2 WASHERS,one (I) 1/2 LOCKWASIIER,and one C[) IP-

10.Carefully stand the MAINBACKSUPPORTASSEMBLY(from previous step) in its upright position and slide it into position to connect with the WEIGHTSTACKSUPPORTBASE.Loosely assemble this connection using, two (2) 1/2 X 3-1/2 BOLTS,four (4) 1.'2 WASHERS,two (2) 1~ LOCKWASHERS,

and two (2) 112 NUTS.

11.Loosely assemble the REARLEFT UPRIGHT(NOTE: THIS UPRIGHTHAS FIVE (5) HOLES THROUGHIT) and the REARRIGHTUPRIGHTto their respective sides at the TOP and BOTTOM CONNECTIONPOINTS as follows:

At the TOP CONNECTIONPOINT, loosely assembling to the TOP BOOIV[SECTION,use one (1) 1/2 x 7-1~ BOLT,two (2) 1.2 WASHEIIS,one (1) 1/2 LOCKWASHER,and one (1) NUTon the outside bolt connection. Use one (1) 3/8 X 7-I/2 BOLT,two (2) 2/8 WASHERS,

(1)318 LOCI(WASHERS,and one (1) 3/8 NUTon the inside bolt connection. NOTE:ONE

318 DIA. x 2 LG. BUSHINGPULLEYmust-be assembled between the tu~es on the inside bolt connection (SEE DETAIL"B").

At the BOTTOMCONNECTIONPOINT, loosely assembling to the CONNECTORFLATS on the WEIGHTSTACI~SUPPORTBASE, use two (2) I/2 x 3 BOLTS,fo,~r (4) WASI-IERS,two (2) 1/2 LOCKWASI-IERS,and two (2) 112 NUTS.BE CA_I~.EFUL

PLACE REAR RIGHT AND LEFT UPRIGHTS ON THE CORRECT SIDES OF THE ¯ CONNECTORFLATS on the WEIGHT STACK SUPPORT BASE.

12.Securely mount the BACKPADto the MAINBACKSUPPORTusing, two (2) 3/8 x 1-1/4 BOLTS,two

(2)318 LOCKWASHERS,and two (2) 3/8 WASHERS.BE SURE TO POSITION THE PAD THAT THE METAL HIDEM WELT CLIP IS POSITIONED IN THE DOWNPOSITION.