Step 4
a) | If a wall stud is found, drill a pilot hole into the stud at each mark, |
| then move to Step 5. OR |
b) | If no stud is found, install wall anchors at each mark following the |
| instructions for the type of wall anchor you are using. CAUTION: |
| We strongly recommend contacting a professional contractor |
| for this type of installation.Every effort has been made to provide |
| accurate and |
CONTROL
Remote Control
The supplied remote requires one lithium battery (included).The remote turns the power on and off, switches between inputs and controls volume.
Electronics Inc. disclaims liability for difficulties that may arise |
from the misinterpretation of information contained in these |
instructions. |
| Step 5 |
Fig. 5 | Using the screws, attach the first wall bracket |
| to the wall. DO NOT completely tighten |
| screws (Fig. 5). |
Step 6
Repeat all steps for the second bracket. Use a level to make sure the brackets are completely straight before tightening screws.
Press to | Press to | |
silence the | ||
select | ||
system. | ||
Input | ||
Press again | ||
| ||
Press | to restore | |
sound | ||
to turn | ||
| ||
system |
| |
on & off | Press and | |
| ||
| hold for | |
| increased | |
| volume | |
| Press and hold | |
| for decreased | |
| volume |
Battery Installation
Follow the diagram on the back of the Remote for correct insertion.
+to + and – to -.
IMPORTANT:
If you lose the remote contact Paradigm at
IMPORTANT: Attach audio cables BEFORE mounting soundbar to wall brackets. See
Onboard Interface
Step 7
Move soundbar into place directly over brackets and gently push it to the wall making direct contact with brackets. You will hear a CLICK as each bracket makes contact with the soundbar. DO NOT release soundbar from your grasp until you hear those two clicks.
Press to turn | Press to | Press to synch | Press and | Press and |
system | select | soundbar and | release to | release to |
on and off | Input | subwoofer | decrease | increase |
|
|
| volume | volume |
|
|
|
| 6 |
