2.0INSTALLATION
CAUTION Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when handling this equipment.
2.1Unpack and Inspect the SAM2000GV
If there is visible damage, do not attempt to connect the device; contact Customer Support at
2.2Install the SAM2000GV in an IP DSLAM Chassis
NOTE There must be a Multiplexer Uplink Module (MUM) installed in your IP DSLAM chassis in order for interface modules to operate.
Net to Net Technologies' IP DSLAM interface modules are hot swappable; installing or removing an interface module while the chassis is powered up does not affect the operational status of other interface modules within the chassis. The IPD12000 is a fourteen slot chassis; slots
zAlign the SAM2000GV with the module guides in the slot chosen for installation (slot
zSlide the SAM2000GV firmly into the chassis. DO NOT USE EXCESS FORCE.
zSecure the SAM2000GV by tightening the fastening screws on the module faceplate.
zVerify that the PWR (Power) LED on the SAM2000GV faceplate is illuminated.
2.3Connect the Voice and SHDSL Lines
2.3.1VoSHDSL RJ21 Pinout
Plug the VoSHDSL cable into the RJ21 port, of the chosen slot, on the back of your IP DSLAM. The RJ21 connector has 50 pins: pins